Omni Basement Systems Before & After Photos

Bob and Sharon have a poured concrete basement in Brantford, On that need to be waterproofed. there was leaking from the footing wall joint that was making the walls wet and moldy. It was time to fix this problem. First step was to tear-out the finished walls. There was considerable amount of water under the slab so Omni decided to add the sump system as soon as possible. The Sump installed was the incredible Triplesafe system. The Triplesafe features three sumps in one liner. Two of the pumps are A.C. powered, cast-iron, Zoeller pumps. The third pump is a D.C. powered, battery back-up pump that has it's own power cell and charger. 

Later, Omni went back and did the waterproofing. The patented drain system, WaterGuard was installed along with the Cleanspace wall membrane. 

Jim F. in Brantford, On needed some waterproofing in his home that has a block foundation. Omni Basement Systems installed their patented drain system called WaterGuard and connected it to Jim's existing sump system. As a wall membrane, Omni installed Cleanspace. This is a 14mil thick liner that is mechanically attached to the wall. This wall membrane will allow moisture from the wall, to drain down to the waterguard drainage system. 

Joan had a crawlpace in her split level home in Caledonia and needed to waterproof plus insulate. 

Omni installed their patented drain drain system with a Sump system and foam insulation to the walls. 

Judy and Tom needed a new sump pump system in their Brantford, Ontario, home. Omni Basement Systems recommended the incredible Triplesafe Sump system. 
The Triplesafe features three pumps in one sump liner. Two of the sumps are cast-iron, submersible Zoeller pumps, and the third is a DC-powered backup system that also comes with a 120 amp/hr power cell and a smart charger. 

 Greg has a home with a poured foundation wall that has some serious cracking. The concern is that it may be structural related. 

Omni Basement Systems used our very own Carbon Armor system from Supportworks to strengthen the wall so it will not tip in or bow. 

The Carbon Armor are 7" wide Carbon fiber strips that are epoxied to the wall. Also there are carbon armor straps that lock the wall to the floor joist system via the rim joist.